Manaras-Opera recommends the use of BRACKET111 for hood-mount application.Locate the four mounting holes, as shown in Figure 7.
![]() In one simple step and by pulling the hand chain in the desired direction, the following operations may be successfully completed, see Figure 14. With such installation, the door is prevented from running out of the tracks. The clutch (torque limiter) will prevent any damage to occur to the door system. Remove BLUE wire from pin 4 on Reversing Relay (RR) and cap it. If the door does not open or close freely, correct the cause of the malfunction. Verify the current consumption of the unit with an amp-meter. The current value should be consistent with the nameplate specifications. Push solenoid plunger to reduce tension when removing or installing the band brake. Manually push the plunger onto the solenoid body, and verify that the brake drum rotates easily by hand. ![]() Manaras-Operas responsibility to any such Third Party shall be no greater than Manaras-Operas responsibility under the warranty to the original Buyer.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |